Carl Goldberg Products EXTRA 300, Instruction Manual

Page: 26 / 44

26
1.
■ ■
Gather all of the par ts needed to construct the
FUSELAGE. They include:
(2) D/C SHT. 5501 PLY SIDES PT. #3475
(1) D/C SHT. 5502 PLY FUSE BOTTOM PT. #3473
(1) D/C SHT. 5503 PLY PT. #3474
CONTAINING TOP & BACKUPS
(1) D/C SHT. 5504 PLY PT. #3475
CONTAINING DOUBLER, TRIPLER, FORMERS &
FUEL TANK TRAY
(1) D/C SHT. 5505 PLY PT. #3476
CONTAINING DOUBLER, TRIPLER & FRMRS
(1) D/C SHT. 5506 PLY FRMRS & GAUGES PT. #3477
(1) D/C SHT. 5507 PLY FORMERS PT. #3478
(1) D/C SHT. 5508 PLY FORMERS PT. #3479
(1) D/C SHT. 5509 PLY FIREWALL PT. #3480
(1) D/C SHT. 5518 PLY TURTLEDECK PT. #3481
(1) 1/32” PLY FRONT/TOP SHEET PT. #4602
(1) BASS WING MOUNTING BLOCK PT. #4372
(1) 1/4” PLY LANDING GEAR BLOCK PT. #4373
(2) BASS MOTOR SPACER PT. #4374
(1) 1/2” x 7” BALSA GUSSET PT. #4217
(2) 1/8 x 1/2 x 18” BALSA STICK PT. #4376
(6) 6-32 BLIND NUT PT. #1124
(6) 6-32 x 1-1/4” SOCKET HD. SCREW PT. #1024
(2) #6x3/4” WASHER PT. #1144
(4) #6 x 3/4” SHT. METAL SCREW PT. #1082
(2) MAIN LANDING GEAR WIRE PT. #1322
(2) MOTOR MOUNT PT. #1466
2.
■ ■
Carefully remove the parts from the die sheets and
lightly sand the rough edges of each part.
3.
■ ■
With the scribe lines exposed, glue FIREWALL
FORMER “AF” to the other firewall half. Make sure the
top and side edges match. Note the bottom offset fit.
Tape together and allow the assembly to dry on a flat
surface.
■ ■
Drill a 3/8” diameter hole at the center mark.
CONSTRUCTING THE FUSELAGE (36 Steps)