Carl Goldberg Products EXTRA 300, Instruction Manual

Page: 20 / 44

20
22.
■ ■
Drill a 5/16” diameter hole at the center mark of both
discs. Then, slide the dowel through the Leading Edge,
the support, and the dowel guide.
■ ■
Insert the remaining front portion of Rib #1 onto the
dowel. Generously EPOXY the entire front rib area, as
well as the dowel support tabs in Rib #2.
23.
■ ■
Crack off all of the support tabs.
■ ■
Glue the remaining pretrimmed L.E. sheeting to the
wing. Pin or tape to secure until dry.
■ ■
Fit and trim the T.E. sheeting and glue to the wing
NOTE: IF YOU ARE USING THE TWO-SERVO
OPTION, GO ON TO STEP 31.
24.
■ ■
Bend a 5/16” x 900 angle at one end of the .063
diameter x 20-3/4” wire pushrod.
■ ■
Install an aileron bellcrank onto the bend. (See plan for
correct orientation.) Secure with a snapnut. Place a
drop of JET glue on the snap-nut.