7
6. Drill two 3/32" [2.4mm] holes through the elevator using
the control horn as a guide. Remove the control horn and
harden the holes by applying two or three drops of thin CA
in each hole. After the CA has hardened, attach the control
horn to the elevator using two 2-56 x 3/8" [9.5mm] screws
and the control horn back plate.
Servo
Grommet
Brass Eyelet
Servo Tray
Screw
7. Install the servos using the hardware included with
your radio system. Again, apply a couple of drops of thin CA
to harden the screw holes.
8. Wrap the receiver and receiver battery in 1/4" [6.4mm]
thick foam. Position the receiver and receiver battery in the
fuselage as shown. Remove the receiver switch cover from
the receiver switch. Position the switch cover on the outside
of the fuselage, between the receiver and receiver battery.
Mark the two mounting screw holes and the switch opening
on the fuselage. Use a sharp hobby knife to cut out the switch
opening and a 3/32" [2.4mm] drill bit to drill out the screw
holes. Mount the receiver switch on the inside of the fuselage
with the switch cover on the outside.
9. Switch on the transmitter and receiver. Center the
elevator and rudder trims on the transmitter. Remove the
servo arm screw and position the servo arm so that it is
