11
450 BA
Fix it on the loading side of the machine by the four screws. Connect the two hydraulic
tubes and fix the cylinder shaft to the driving carriage.
Fix it to the loading side of the machine by the two screws.
Fix it to the standard roller unit (already fixed to the machine). Some roller units may also
be used separately from the machine.
3.3 How to set up the carriage cylinder
3.4 How to set up the standard roller unit for bar support l = 1 m and
how to set up the optional roller unit for bar support
The hexagonal nuts “1” and “2” are pre-adjusted in order to obtain the right
cutting length. Do not unclamp them.
•
Please be sure that power supply tension
is conformed to the characteristics of
the machine.
•
Environment Temperature between
-10°C (-50°F) and + 50°C (122°F).
•
Humidity not more than 90%.
•
Ensure to have a working space sufficient
to allow the entire safety of the machine.
•
Keep the back of the machine at least
800mm (2.6 ft) from the wall.
•
Place the machine on a leveled and
straight floor.
•
Leveled the machine and eventually
make the foundation in the 4 points of
the basement, as picture below.
3.2 Installation Plan
Summary of Contents for 450 BA
Page 2: ...450 BA...
