Carel FLSTDMFC0A, Manual

Page: 32 / 56

FLSTDMFC0A pCO² refrigeration system
cod. Carel +030221991 rel. 1.0 dated 27/07/01
26
defines the type of outlet probe connected
defines the position of the outlet probe (B2 or B8); for Medium or Large boards only
Sets the limits for the inlet probes
Sets the limits for the outlet probes
sets the type of freon used
(used to convert from pressure to temperature)
can be configured: none, R22, R134a, NH3, R404a
The position the various digital inputs for the compressors on the board can be configured.
The software automatically limits the inputs that are already occupied
The following inputs can be used:
Œ
all the digital inputs
Œ
analogue inputs B4,B5, used as digital
Œ
analogue inputs B9,B10 (Large board only) used as digital
To reverse the position of two inputs, proceed as follows:
1. Position the first device on input --
2. Position the second device on the previous input of the first device
3. Position the first device on the previous input of the second device
Note: if a device remains configured at position --, it is not considered
Position of the digital inputs used as safety devices for the compressors
Position of the digital inputs used as safety devices for the fans
Position on the board of the digital input used as an external ON-OFF
this parameter is only displayed if enabled
this parameter is only displayed if enabled
Position on the board of the digital input used as
general low pressure switch
general high pressure switch
these parameters are only displayed if enabled
m_conf_probe2
2XWOHWSUREH
W\SH
17
C
%RDUG,QZLULQJ%
m_conf_probe3
,QSUHVVHQGVFDOH
0LQ0D[
2XW
press. end scale
0LQ0D[
m_conf_freon
7\SHRIIUHRQ
---
m_conf_inout_1
%RDUGGLJLQZLULQJ
FRPS2YHUO
&RPSRLOGLII
+3/3SUHVV&
m_conf_inout_2
%RDUGGLJLQZLULQJ
FRPS2YHUO
Comp2 oil diff.00
+3/3SUHVV&
m_dig_on_off1
%RDUGGLJLQZLULQJ
2Q2IIE\GLJLWDO
L
nput 00
m_dig_on_off2
%RDUGGLJLQZLULQJ
/LTXLGOLYHO
DO
arm 00
m_conf_main_pss
%RDUGGLJLQZLULQJ
*HQ/3SUHVV
*HQ
.HP press.: 00