8528-M372-O1 Rev E
PZ3000 Series
3
INSTALLATION
1. Carefully remove the scale base and display from the shipping carton and inspect them for
any evidence of damage (such as exterior dents and scratches) that may have taken place
during shipment. Remove the packing material from the scale base and on the PZ3030, the
shipping screw on the bottom of the scale base. Next, remove the protective covering from
the display and keypad. Keep the carton, packing material and shipping screw (on the
PZ3030) for return shipment if it should become necessary. NOTE: It is the responsibility of
the purchaser to file all claims for any damages or loss incurred during transit.
2. To mount the display on the scale base, locate the two mounting screws on the display and
the two slotted holes in the scale base bracket.
3. Lift the scale (by the bracket) high enough to allow you to align the two screws on the
display with the large end of the two slotted holes in the bracket. Place the screws on the
display in the bracket and gently pull forward to secure the display to the bracket.
4. Plug the AC power supply into the power jack, located on the bottom side of the display (refer
to Figure 1) and then connect the AC power adapter into the proper electrical outlet.
5. If it is desired to use the scale remotely (no AC power), with the exception of the PZ3060, you
must first obtain and install 6 NiMH batteries (2300mAh minimum). The batteries should then
be allowed to charge approximately 8 hours. Charging the batteries for more than 8 hours
will not harm them. The scale may be operated while the batteries are charging.
6. Place the scale on a stable, vibration-free, level surface away from direct sunlight and any
rapidly moving air source (heating and cooling vents).
7. Place commodity tray on the scale. The scale is now ready to use.
CAUTION! DO NOT place the scale on any unstable cart, stand or table. The
scale may fall causing injury to the operator, and seriously damage the unit, or
proper operation of the scale may be inhibited.
Optional
Zero Device
Connector
Power
Supply
Jack
Scale
Base
Cable
Display
Mounting
Screws
Figure No. 1
Summary of Contents for Detecto PZ3000 Series
Page 2: ......
Page 19: ...8528 M372 O1 Rev E PZ3000 Series 17 PARTS IDENTIFICATION PZ3015 Base Assembly ...
Page 21: ...8528 M372 O1 Rev E PZ3000 Series 19 PARTS IDENTIFICATION PZ3015L PZ3030 Base Assembly ...
Page 23: ...8528 M372 O1 Rev E PZ3000 Series 21 PARTS IDENTIFICATION PZ3060 Base Assembly ...
