12
7.5.2 Reinstalling the Drawers
To reinstall the drawers, complete the following steps
(refer to
Figure 4
):
1. Pull both the slides of the drawer towards you until the slides are fully extended.
2. Position the drawer between the slides and with the back facing end raised at 45 degree angle,
insert the mounting clips at the front into the slots on front of the slides.
3. Push the back of the drawer down between the slides and insert the basket tabs into the slots at the back.
Note
The drawers fit snugly between the slides. Push on the back of the drawer from the inside to insert the
drawer tabs completely into the slots. Make sure both the drawer tabs are aligned with the slots on the
slides before pushing the drawer down between the slides.
CAUTION:
Be careful when reinstalling the drawers to avoid possible pinching.
7.5.3 Changing Drawer Position
Drawer slides have a small wire safety clip at the front pilaster which prevent the slides from falling when the drawer is
removed. To change the position of the drawer slides, complete the following steps:
1. Locate the safety clip.
2. Slip a small screwdriver under the bottom of the wire clip and pry the clip towards the inside of the refrigerator.
Figure 5. Clip Removal
3. Lift up the slide at the front. The slide is free to move from the front pilaster.
Figure 6. Front of slide Removal
4. The drawer slide must be removed from the rear pilaster at approximately a 45 degree angle
towards the center of the cabinet.
