Cardiac Science POWERHEART AED G3 9300A, Quick Reference Manual

Page: 15 / 32

Powerheart® AED G3 9300A and 9300E 70-02006-01 A 2-7
Intellisense battery
Battery installation
To install the battery:
1.
With the label on the
battery facing the AED
battery compartment,
insert the battery as shown
in the drawing.
2.
Push the latched end of the
battery firmly into the
AED, as shown in the
drawing, until the battery
snaps into place. The
exposed side of the battery
should be flush with the
outside of the AED case.
3.
Wait a few seconds and
then open the lid for 5
seconds to initiate a self-
test.
If the battery is installed
properly:
• The Smartgauge
battery indicator LEDs illuminate.
• The Rescue Ready status indicator turns green.
If service is required, the Service indicator illuminates instead.
Contact Cardiac Science Technical Support (see Contact
information on page 1-2) or outside the U.S., your local Cardiac
Science representative.
0% 100%