Page 36
12. Attachment
12.4
Technical specifications
Electrical data
Connected loads
230 V
Frequency
50 Hz
Power consumption
0.7 A
Power input – operation
0.20 KW
Power input – stand-by
approx. 3.9 W
Operating mode (time)
2 min.
Control voltage
24 V DC
Protection category motor head IP 20
Protection class
II
Lighting
1 x 40 W E14
Mechanical data
Door travel speed
0.14 m/s with "soft" start and "soft" stop
Max. push and pull force
650N
Nominal force
150N
General data
Temperature range
-20 to 60 °C
Features / Safety functions
- Reference point technology
- Soft-Start / Soft-Stop
- Delay safety device
- Automatic cut-out
- Blocking protection
- Under voltage protection
- Excess travel stop
- Electronic travel cut-out
- Connection for pushbuttons, code buttons and key switches
- Connection possibility of potential-free limit switch message for signal light circuit board
- Error messages
Accessories
- Modular antenna, 868 MHz, IP 65
- Mounting supports for sectional doors
- Release kits for swinging doors
- Adapter arm for retractable up-and-over doors
- Fittings for winged doors
- Photocells
- Emergency release kits
8.2.A
1-Piece up-and-over doors
1.
Install door bracket at centre position of door and
rail bracket on centre position above door. Make
sure there is at least 10 mm. clearance between
highest travel point of door and rail.
2.
Level and mount operator.
3.
Disengage carriage from chain or belt!
Door may only be moved with moderate speed.
4.
Connect operator pull bar to door bracket.
Attention:
Remove or disable all door locks before
installation!
Page 9
min. 35 mm
10 mm
P
8.2.A / 1
8.2.A / 2
8.2.A / 3
8.2.A / 4
8.1
Determine garage door type
Determine your garage door type as indicated in Step 8.2.A, 8.2.B, 8.2.C, 8.2.D
Follow the individual instructions required for your specific garage door type.
If your garage door type is not included, please contact your distributor.
Special accessories or operator modifications may be required.
8.
Operator Installation
