Carbatec TJ-X300C, Owner'S Manual

Page: 9 / 45

1 6mm Hex Wrench (included)
1 10mm Box Wrench
1 13mm Box Wrench
Note:
se of sockets and ratchets will speed assembly time but are not required.
Electrical Connection
All electrical connections must be done by a qualified electrician. All
adjustments or repairs must be done with the machine disconnected
from the power source, unplugged. Failure to comply may result in
serious injury!
he Model P 310 Jointer-Planer is rated at 230 . his machine is not supplied with
a plug. se a plug and outlet rated at least 20amps.
he circuit for the machine should also be protected by at least a 20 amp circuit
breaker or fuse.
Make sure that the cutterhead moves in thecorrect direction.
If it does not, simply
reverse two of the phase wires on the supply input.
Operating Controls
Disconnect machine from power source before making any adjustments.
Failure to comply may cause serious injury.
Cutterhead knives are dangerously sharp. Use extreme caution when
working around them. Failure to comply may cause serious injury.
Jointer to Planer Setup
o change the machine configuration jointer to planer (refer to Figure 2):
1. elease both cabinet table locks (A) by rotating the handles toward the operator,
then pulling away from the machine.
2. aise the table (C) using the handle (B).
The TJ-X250C and TJ-X300C Thicknesser / Jointers are designed for use when
connected to 230V circuits, fitted with a 15 Amp power outlet. DO NOT use on 10A
circuits, or modify the machine to allow connection to these lesser rated circuits.