Carbatec TJ-X300C, Owner'S Manual

Page: 17 / 45

direction.
8. Insert lock bar (B) and tighten just enough to hold in place.
9. epeat for other two blades.
Jointer Table Lock Handle Adjustment
For best performance, the jointer table lock handles (A2) should be approximately in
the fully down position when in the locked position. If adjustment is required:
1. Disconnect machine from power source.
2. nlock the lock handle (A2) and raise the table to the upright position.
3. Loosen locking nut (C2) with an 18mm wrench.
4. Adjust the table locking shaft (C1) in increments of 1/4 turns or less. urn
clockwise to tighten the lock handle performance and counterclockwise to loosen.
5. ighten the locking nut (C2).
6. est the locking function and repeat if necessary.
Belt Replacement
Disconnect machine from power source before making any adjustments.
Failure to comply may cause serious injury.
Preparation
o replace the cutterhead drive belt and/or the planer
feed-roller belt, the jointer fence assembly and two
back panels must first be removed as
described below. A 4mm hex wrench and two 13mm
wrenches are required.
1. emove the jointer fence assembly (A) by first
loosening and removing two lock handle assemblies (B).
A 4mm hex wrench is helpful, but not necessary.
2. emove two button head socket screws (C)
and upper back panel (D).
3. emove four button head socket screws (O)
and lower back panel (P).
Cutterhead Drive Belt Replacement
4. Loosen four motor mount screws (L). Lift the
motor and rest it in the horizontal slot side of
the motor mount opening. his will create a
slack in the cutterhead drive belt (F).
5. emove the cutterhead drive belt (F) from
around the cutterhead pulley (E) and motor
pulley (M).
6. If the feed-roller belt (K) is to be replaced,
continue. Otherwise proceed to step 10.
Feed-roller Belt Replacement
Note:
If the feed-roller belt is to be replaced, steps
1–5 must be performed to remove the cutterhead
drive belt before the feed-roller belt can be