Carbatec TJ-X300C, Owner'S Manual

Page: 24 / 45

3. o protect the infeed table from scratches, partially cover the sharpening stone
with paper (Figure 22).
4. Lay the stone on the infeed table.
5. Lower the infeed table and turn the cutterhead by turning the cutterhead pulley.
he infeed table height is set properly when the stone's surface is flush with the
knife bevel.
6. Keep the cutterhead from rotating by grasping the cutterhead pulley while sliding
the stone back and forth across the table.
7. ake the same amount of passes for all three blades.
hen the blades have been sharpened and still are not cutting efficiently, trying to
touch up the blades further will only cause the formation of a second beveled edge.
hen this starts to happen, it is time to replace blades with another set. It is
recommended to keep a second set of blades on hand so that they may be installed
while the first set is being professionally sharpened.
Lubrication
se a good grade of light grease on the steel adjusting screws located in the
raising and lowering mechanisms of the work tables.
he cutterhead ball bearings are lifetime lubricated and need no further care.
Troubleshooting
Performance Troubleshooting – Jointer