Carba-Tec CTH-110L 1PH, Owner'S Manual

Page: 14 / 32

www.carbatec.com.au
Assembly Instructions
Setting 45° and 90° Positive
Stops
The stops have been adjusted at the factory. After a
period of use, or, after moving the saw to another
location, the stops may no longer be set properly. To
check and adjust the stops:
1. Raise the saw blade to its maximum height using
the handwheel.
2. Set the blade at 90 ° to the table by turning the
blade tilting handwheel clockwise as far as it will go.
3. Place a square on the table and check to see that
the blade is at a 90
° angle to the table. Make sure
square is not touching a blade tooth. See Fig. 19.
4. If blade is not at 90 ° , open the motor cover door,
loosen lock nut (A) and turn adjusting stop screw (B)
on the front trunnion in, or out. The adjusting stop
screw should stop against the front trunnion bracket
when the blade is 90
° to the table. See Fig. 20.
5. Tighten the lock nut (A).
6. Set the blade at 45 ° to the table by turning the
blade tilting handwheel counter clockwise as far as it
will go. Place a square on the table. See Fig. 21.
7. If the blade is not at 45 ° , remove the raising and
lowering handle. Loosen lock nut (A) and turn
adjusting stop screw (B) on the front trunnion in, or
out. The adjusting stop screw should stop against the
front trunnion bracket when the blade is 45
° to the
table. See Fig. 22.
8. Check the accuracy of the pointer (C) on the
angle scale and adjust if necessary.
14
WARNING
MAKE CERTAIN THAT THE SAW IS
DISCONNECTED FROM THE POWER SOURCE.
Fig.19
Fig.20
Fig.21
Fig.22