Motor Brace Disassembly
A motor support brace has been installed for shipping
purposes only. Remove this brace before assembling
the saw. See Fig 1
Motor Cover Assembly
Install motor cover by aligning holes in the motor cover
with pins on the cabinet hinge. See Fig 2
Extension Wing Assembly
NOTICE:
There is a specific Left wing and Right wing.
When attaching the wings to the saw,
MAKE CERTAIN
that the beveled edges of the wings face towards the
front of the saw.
1. Attach extension wing to the table with three hex
head bolts, three lock washers, and three flat washers.
Do not fully tighten them at this stage. See Fig 3
2. Slide the beveled end of the extension wing towards
the front edge of the saw table until the beveled edges
are flush.
3. Using a quality straight edge (A), align the extension
wings to the saw table. See Fig 4. Now tighten the hex
head bolts shown in Fig 3.
4. Repeat Steps 1-3 for the other wing.
Hand Wheel Assembly
1. Line up the key on the shaft with the keyway in the
handwheel (A), and slide the handwheel onto the shaft.
2. Tighten the set screw on the handwheel hub
securely to hold in place.
3. Install center lock knob (B) by inserting into center
hole in the shaft and threading in a clockwise direction.
See Fig 5.
Assembly Instructions
www.carbatec.com.au
9
A
A
A
B
B
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Summary of Contents for CTH-110L 1PH
Page 31: ...Notes www carbatec com au 31...
