5. If they are not the same, loosen the four socket
head cap screws(A) that hold the table to the base.
Two are shown in Fig. 17, there are two more on the
opposite side of the machine.
6. Make the required adjustments by moving the cast
table top, and then tighten the four hex socket cap
screws firmly.
7. Check the alignment once again after tightening
hardware.
Mitre Gauge Adjustment
1. Adjustments in the zero reading can be made by
re-calibrating the position of the pointer. Simply
loosen the phillips head screw, adjust the pointer and
tighten the screw See Fig.18.
2. Adjust fit of the mitre gauge assembly in the mitre
slot by adjusting set screws located in the side of the
steel tie bar, in or out. Make sure adjustments do not
prevent the mitre guage from travelling freely in the
mitre slot. See Fig. 19.
Other machine adjustments may be shown in the
‘Maintainence’ Section of this manual.
www.carbatec.com.au
13
A
Assembly Instructions
Fig.17
Fig.18
Fig.19
Summary of Contents for CTH-110L 1PH
Page 31: ...Notes www carbatec com au 31...
