34
33
3
5
4
6
OR
If updating has not started
If updating has failed
OR
*Wait for at least three seconds after attaching the battery pack
before pressing and holding the switch button.
Connect
the power cable
Turn on
the car engine
Attach
the battery pack
Press and hold
the switch button for
more than two seconds
TOP
K
P34
P33
2017.01月
初
版
Mac
Illustrator
CS6
DC3000
Using
this Product
Safely
Preparation
Installation
Capturing
Images/V
ideo
V
iewing/Deleting
Media
Changing
Camera Settings
T
roubleshooting
Connecting the memory card to your computer
Connect the memory card to your computer either by directly connecting the communication cable
(included with the Product) to the camera body, or by using a third-party card reader.
Switching on the camera
Switch on the camera by doing either of the following:
*Attach the camera body to the mount. Insert the microUSB connector of the power cable into
the camera body, and turn on your car engine (turn on the ignition).
*Attach the fully charged battery pack to the camera body. Press and hold the switch button
for more than two seconds.
*The camera body will begin updating automatically a few seconds after the camera body is switched on.
During this update, all LEDs except the memory LED will start blinking in red.
*Do not turn off the power, press any buttons, or insert/remove the memory card until the red
blinking turns off.
*The switch button LED is blinking orange (indicating an error)
> Remaining battery level is insufficient for the update to take place. Fully charge the battery and
repeat procedure 6.
*All LEDs are off
> Check the power connection and remaining battery level.
*Repeat all the procedures on page 32.
Copying the extracted firmware file onto the memory card
On your PC, open the “FIRMWARE” folder saved on the memory card.
Copy and paste into this folder the “firmware.bin” file you extracted in procedure 2.
*Do not change the file name “firmware.bin”.
*Do not remove the memory card during data transfer.
Reinserting the memory card into the camera body
When the file has finished copying, remove the communication cable.
If the connection has been made via a card reader, remove the memory card from
the reader and insert it back to the camera body.
