Version 08.04.2021
HW CAM(V31)/(V22)
CI-RL2-RLINK
P
a
g
e
6
1.3.2.
CAN-box
The CAN-box reads digital signals from the CAN-bus and converts them for the video-
interface.
2.
Installation
Switch off ignition and disconnect the vehicle’s battery! The interface needs a permanent
12V source. If according to factory rules disconnecting the battery is to be avoided, it is
usually sufficient to put the vehicle to “Sleep-Mode”. In case it does not succeed,
disconnect the battery with a resistor lead.
If power source is not taken directly from the battery, the connection has to be checked
for being start-up proven and permanent.
2.1.
Place of installation
2.1.1.
Place of installation – video interface und CAN-Bus box
The interface boxes shall be installed behind the vehicle`s head-unit or the glove
department, depending on equipment and space.
2.1.2.
Place of installation - daughter PCB
The interface’s daughter PCB is prepared to be installed between the head unit’s housing
and the monitor panel.
For this purpose the housing of head-unit have to be opened.
