10
5.
CapDRIVE
installation
Cap
DRIVE
can be installed directly on the fan cover of the motor or mounted on the wall.
Motor mounting kit
In this application CapDRIVE is cooled by the motor fan. Motor kit (available upon request) allows a solid coupling of the two
units and it is composed of:
CapDRIVE 011, 030, 022, 040
n.°4 rods
n.°4 M5 nuts
Qty 4 x spring washer
n.° 4 hooks
n.° 1 cooling ring
CapDRIVE 055, 075, 110, 150
n.° 4 M5 screws.
n.° 4 clamps
n.° 4 clips to add if necessary
N.°1 centre pin
Use the cooling ring for best cooling of CapDRIVE during
operation. Warning: when using the cooling ring, the cooling
air of the motor is slightly warmer than without the
CapDRIVE; if the resulting motor temperature exceeds the
indicated maximum allowable value, remove the cooling
ring, leaving the CapDRIVE to be cooled by itself.