29
Electrical connection
The installation of this appliance and the connection to the electrical network should
be entrusted only to an electrician following the required regulations.
Protection against the parts under tension must be ensured after the installation.
The information on the connections are on the stickers. Place them on the hob casing
near the connection box.
Connection to the mains must be made using an omnipolar circuit breaking device
with a contact opening of at least 3 mm.
The electrical circuit must be separated from the network by adapted devices, for
example: circuit breakers, fuses or contactors.
If the appliance is not fitted with an accessible plug, a disconnecting means must be
incorporated in the fixed installation, in accordance with the installation regulations.
The inlet hose must be positioned so that it does not touch any of the hot parts of the
hob or oven.
Caution!
This appliance has only to be connected to a network 230 V~ 50/60 Hz.
ALWAYS connect the earth wire.
Respect the connection diagram.
The connection box is located underneath at the back of the hob casing. To open the cover
use a medium screwdriver, place it in the slits and open the cover.
Connecting the hob:
* calculated with the simultaneous factor following the standard EN 60 335-2-6
Setting up the configurations:
For the various kinds of connection, use the brass bridges which are in the box next the
terminal.
Mains
Connection
Supply cord
Supply cord
Circuit braker
230V~ 50/60Hz 1 Phase + N
3 x 2,5 mm²
H 05 VV - F
H 05 RR - F
25 A *
400V~ 50/60Hz 2 N
4 x 1.5 mm²
H 05 VV - F
H 05 RR - F
16 A *
