27
Installation instructions
The installation comes under the exclusive responsibility of the installer.
The installer must respect the local legislation and the standards in force.
How to apply the gasket:
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
Installation has to be done carefully, in conformity with the following drawing.
Fitting - installing:
The cut out sizes are:
Product code
Cut-out size
C900I
810 x 490 mm
Ensure that there is a distance of 50 mm between the hob and the wall or sides.
The hobs are classified as “Y” class for heat protection. Ideally the hob should be
installed with plenty of space on either side. There may be a wall at the rear and tall
units or a wall at one side.
On the other side, however, no unit or divider must
stand higher than the hob.
The worktop or the support in which the hob is to be fitted, as well as the edges of
furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
The mural rods at the edge must be heat-resistant.
Do not install the hob to the top of a non-ventilated oven or a dishwasher.
The underside of the hob has a casing
space of 20 mm
to ensure a good air
circulation of the electronic device.
Stick the gasket (2) 2mm from the
external edge of the glass, after
removing the protection sheet (3).
