23
Ensure that the pan is dry and clean before use. Ensure that there are no grains of
dust on your ceramic hob or on the pan. Sliding rough saucepans will scratch the
surface.
Spillages of sugar, jam, jelly, etc. must be removed immediately. This will prevent the
surface being damaged.
Do not use a steam cleaner to clean the appliance.
What to do in case of a problem
When the symbol [ E 4 ] appears:
I)
The table must be reconfigured. Please implement the following steps:
Important : before you start:
make sure there are no pots on the hob
take a pot with a ferromagnetic bottom and a minimum diameter of 16 cm
disconnect the appliance from the mains supply by removing the fuse or turning the
circuit breaker off
start the procedure within 2 minutes after reconnecting the hob to the electrical supply
reconnect the hobs electrical supply
don‟t use the [ O/I ] touch control
II)
First step: cancel the existing configuration
1)
Press the touch B and hold down
2)
With your other hand, press on the
touch A for 2s. Release the touch A.
A “beep” sound and the half slider lights.
A double "beep" means an error occurred.
If so, start again from item 1).
3)
With your finger slide on the slider from right
to left, always with your finger on the touch B.
A “beep” sound if manipulation is successful, If not, start again from
item 1).
4)
Remove your fingers from the touch control, then push again on touch A for
a few seconds, until a blinking [ E ] symbols appear.
5)
Wait until [ E ] symbols stop blinking.
6)
After few seconds, [ E ] is automatically transformed into [ C ]. The existing
setup has been cancelled.
