Instruction manual C856i
Please keep this instruction manual for future reference
33
Before installing the hob
- The work surface is square and level, and no structural members interfere with
space requirements.
- The work surface is made of a heat-resistant material.
- If the hob is installed above an oven, the oven has a built-in cooling fan.
- The installation will comply with all clearance requirements and applicable
standards and regulations.
- A suitable isolating switch providing full disconnection from the mains power
supply is incorporated in the permanent wiring, mounted and positioned to
comply with the local wiring rules and regulations.
- The isolating switch must be of an approved type and provide a 3mm air gap
contact separation in all poles (or in all active [phase] conductors if the local
wiring rules allow for this variation of the requirements).
- The isolating switch will be easily accessible to the customer with the hob
installed.
- You consult local building authorities and by-laws if in doubt regarding
installation.
- You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the
wall surfaces
After installing the hob
- The power supply cable is not accessible through cupboard doors or drawers.
- There is adequate flow of fresh air from outside the cabinetry to the base of the
hob.
- If the hob is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the hob.
- The isolating switch is easily accessible by the customer.
Before locating the fixing brackets
- The unit should be placed on a stable, smooth surface (use the packaging). Do
not apply force onto the controls protruding from the hob.