5
Instruction manual C775G, C750G, C768G
Please keep this instruction manual for future reference
-
Unstable or misshapen pans should not be used on the
appliance as they can cause an accident by tipping or
spillage.
-
The use of a gas cooking appliance results in the production
of heat and moisture in the room in which it is installed.
Ensure that the kitchen is well ventilated: keep natural
ventilation holes open or install mechanical ventilation
device (mechanical extractor hood).
-
The heating and cooking surfaces of the appliance become
hot when they are in use, take all due precautions.
-
Never leave the appliance unattended when cooking.
-
Do not use or store flammable materials in the storage
drawer near this appliance.
-
Perishable food, plastic items and aerosols may be affected
by heat and should not be stored above or below the
appliance.
-
Do not spray aerosols in the vicinity of this appliance while
it is in operation.
-
Ensure the control knobs are in the ‘ ‘ position when not
in use.
-
Never use abrasive or caustic cleaning agents. Clean with
warm soapy water and a soft damp cloth.
-
This appliance should only be repaired or serviced by
an authorised Service Engineer and only genuine Caple
approved spare parts should be used.
AUTOMATIC IGNITION WITH FLAME FAILURE SAFETY DEVICE
The appliance is fitted with a flame failure safety device on each burner, which is designed to stop the flow of
gas to the burner head in the event of the flame going out.
TO IGNITE A BURNER:
> Press in the control knob of the burner that you wish to light and turn it anti-clockwise
to the maximum position.
> If you keep the control knob depressed, the automatic ignition for the burner will operate.
>You should hold down the control knob for 15 seconds after the flame on the burner has lit. If after 15s the
burner has not lit, stop operating the device and open the compartment door and/or wait at least 1 min before
attempting a further ignition of the burner.
> After this 15-second interval, to regulate the flame you should continue turning the control knob anti-
clockwise until the flame is at a suitable level.
> The operating position MUST be at a position between the maximum and minimum position.
> To switch the burner off, turn the control knob fully clockwise to the gas off position.
> In case of power failure, the burners can be lit by carefully using a match.
> The minimum setting is at the end of the anti-clockwise rotation of the control handle.
> All operation positions must be selected between the maximum and minimum position.
> The symbol on the control panel, next to the control handle will indicate which burner it operates.
The following symbols will appear on the control panel, next to each control handle :
Black circle: gas off
Large flame: maximum setting
Small flame: minimum setting
H O W TO U S E YO U R A P P L I A N C E