18 Instruction manual C775G, C750G, C768G
Please keep this instruction manual for future reference
B U R N E R S
› Remove the burner lids and Flame Spreaders by pulling them upwards and away from the
top plate.
› Soak them in hot water and a little detergent or washing up liquid.
› After cleaning and washing them, wipe and dry them carefully. Make sure that the flame
holes are clean and completely dry.
› Wipe the fixed parts of the burner cup with a damp cloth and dry afterwards.
› Gently wipe the ignition device and flame supervision device with a well wrung-out cloth
and wipe dry with a clean cloth.
› Before placing the burners back on the top plate, make sure that the injector is not blocked.
R E A S S E M B L E T H E AU X I L I A RY, S E M I - R A P I D, R A P I D A N D T R I P L E -
C R OW N B U R N E R S A S F O L L OW S :
1
2
3
4
5
6
7
BURNERS
> Remove the burner lids and Flame Spreaders by pulling them upwards and away from the top plate.
> Soak them in hot water and a little detergent or washing up liquid.
> After cleaning and washing them, wipe and dry them carefully. Make sure that the flame holes are clean
and completely dry.
> Wipe the fixed parts of the burner cup with a damp cloth and dry afterwards.
> Gently wipe the ignition device and flame supervision device with a well wrung-out cloth and wipe dry
with a clean cloth.
> Before placing the burners back on the top plate, make sure that the injector is not blocked.
REASSEMBLE THE AUXILIARY, SEMI-RAPID, RAPID AND TRIPLE-CROWN
BURNERS AS FOLLOWS:
1. Place the flame spreader (4) on to the burner cup (5) so that the ignition device and the flame
supervision device extend through their respective holes in the flame spreader.
The flame spreader must click into place correctly.
2. Position the burner lid (1,2,3) onto the flame speader (4) so that the retaining pins fit into their
respective recesses.
Replace parts in the correct order after cleaning.
Do not mix up the top and the bottom.
The locating pins must fit exactly into the notches.
1. Place the flame spreader (4) on to the burner cup (5) so that the ignition device and the
flame supervision device extend through their respective holes in the flame spreader. The
flame spreader must click into place correctly.
2. Position the burner lid (1,2,3) onto the flame speader (4) so that the retaining pins fit into
their respective recesses.
Neglect of this mark may result in severe personal injury or death.
Danger/Warning
Neglect of this mark may result in minor personal injury or
property damage.
No naked flames
No Access
Must Do
DANGER
If gas appears to be leaking, take the following actions:
-
Do not turn on the light.
-
Do not switch any electrical appliance on or off and do not touch any electric plug.
-
Do not use a telephone.
1 Stop using the product and close the middle valve.
2 Open the window to ventilate.
3 Contact our service centre or gas supplier by using a phone outside.
* The gas contains mercaptan, so that you can smell the gas leak (smell of rotten garlic or egg) even where only
1/1000 of the gas is in the air.
WARNING SYMBOLS
Caution
Replace parts in the correct order after cleaning. Do not mix up the top and
the bottom. The locating pins must fit exactly into the notches.