Capital fireplaces Tucana 600 Inset Instructions Manual Download Page 2

Quick   Start   Guide   

To   get   the   most   out   of   your   stove   you   should   take   the   time   to   read   the   instructions   provided.   If   for   

any   reason   you   don’t   have   these   instructions   contact   your   retailer   and   request   a   copy.   

   

This    guide    is    intended    to    help    you    get    the    best    possible    fire    started.        Even    if    you    have    previous   

experience   with   stoves,   all   makes   and   models   vary   and   the   information   below   will   help   you   gain   the   

optimum   performance   from   your   new   stove.   

   

   

Make   sure   both   the   primary   (bottom)   and   secondary   
(top)   valves   are   open.      The   open   position   is   with   both   
controls   fully   to   the   left   on   the   glass   fronted   and   the   
top   valve   to   the   right   and   the   bottom   turned   
anticlockwise   on   the   Traditional.   

To   start   a   fire,   create   a   small   ‘wigwam’   of   kindling   
towards   the   back   of   the   grate   and   light   it   using   a   
single   firelighter.   

Close   the   door   and   wait   until   the   firelighter   burns   
away   and   the   kindling   is   fully   ignited.   

   

Open   the   door   and   use   a   poker   to   lay   the   kindling   
across   the   width   of   the   grate.      

It   is   best   to   keep   the   fuel   towards   the   back   of   the   
grate   during   these   early   stages.   

Place   a   small   kiln   dried   log   (less   than   15%   moisture)   
on   top   of   the   kindling   and   close   the   door.   

Wet   wood   will   cause   the   stove   window   to   blacken.   

Do   not   cover   the   tertiary   air   holes   (the   small   holes   
located   at   the   rear   of   the   firebox   above   the   back   
brick).   

   

Once   the   log   starts   to   burn   close   the   primary   
(bottom)   valve   by   sliding   it   to   the   right   on   the   glass   
fronted   and   turning   clockwise   on   the   traditional.   

If   you’re   continuing   to   burn   wood   use   the   secondary   
(top)   valve   to   control   the   fire,   we   usually   recommend   
half   closing   it   but   every   installation   will   vary   so   try   
different   settings   until   you   find   one   you’re   happy   
with.      If   you’re   burning   solid   fuel,   such   as   anthracite,   
wait   until   you   have   a   bed   of   hot   ash   and   then   add   
your   fuel.         

The   settings   for   solid   fuel   are   the   opposite   to   wood,   
fully   close   the   secondary   (top)   valve   and   control   the   
rate   of   burn   using   the   primary   (bottom)   valve.   

Don’t   over   fill   the   firebox,   this   is   a   very   efficient   
stove   and   will   generate   plenty   of   heat   with   a   small   
amount   of   fuel.   

   

Primary   Valve   

Secondary   Valve   

Secondary   Valve   

Primary   Valve   

Summary of Contents for Tucana 600 Inset









Reviews: