8
3. Connect end of the touchscreen USB cable to the rear side of the computer and the other
end to the monitor.
4.
Plug the power cord into the power connector on the rear of the monitor. Then, plug the
other end of the cord into a power outlet.
4.
INSTALLING THE DRIVER SOFTWARE
Drivers are located on the enclosed CD-ROM for the following operating systems:
• Windows XP
• Windows 2000
• Windows Me
• Windows 98
• Windows 95
• Windows NT 4.0
The touchmonitor is Plug-and-Play compliant. Information on the video capabilities of
touchmonitor is sent to video display adapter when Windows starts. If Windows detects
touchmonitor, follow the instructions on the screen to install a generic Plug-and-Play
monitor.
Refer to the appropriate section for driver installation instructions.
Installing the USB Touch Driver for Windows XP, Windows 2000, Me, 95/98 and
NT 4.0
1. Insert the CD-ROM in computer’s CD-ROM drive.
If Windows 98, Windows Me or Windows 2000 Windows XP starts the Add New Hardware
Wizard.
2. Choose
Next
. Select “Search for the best driver for your device (Recommended)” and
choose
Next
.
3. When a list of search locations is displayed, place a checkmark on “Specify a location” and
use
Browse
to select the suitable directory on the CD-ROM.
4. Choose
Next
. Once the USB touchscreen driver has been detected, choose
Next
again.
5. You will see several files being copied. Insert your Windows 98 CD if prompted. Choose
Finish
.
Signal Cable
Connector of
Computer
D-sub Signal Cable
D-Sub 15pin
