Canton Spectral VRA 3, Operating Instructions Manual, Page: 81 / 104

3 81
English
8
To leave the menu, press the "M" button.
Notes: • Should you assign a name to an input that is already assigned, the input previously assigned with this name will be deactivated (“- - -“). To
continue using this input, you must assign a different name. Each source name can only be assigned once.
 • Inputs which have been deactivated “- - -” are no longer displayed when changing the inputs (Input buttons).This simplifies the selection of
the desired input.
 • The name for the input BT and NET (Network) cannot be changed.
Input Select [SEL]
If the Input Select function is activated (AUT), the system automatically changes the optical, coaxial, analog and BT input as soon as the signal disappears at
the currently selected signal input and an input signal is detected at one of the speaker’s inputs. If MAN, is selected, the inputs must be selected manually via
the remote control as usual.
To change the Input Select function from MAN to AUT or contrary, proceed as follows:
1
To enter the menu, press the "M" button.
2
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
3
Select the menu item Input Config [INP]. and confirm with the "OK" button.
4
Change the setting using the "+/-" keys and confirm with the "OK" button.
Notes: • The input NET is always selected automatically in case of an incoming audio signal.
• If you want the HDMI inputs to be switched automatically too, please activate the HDMI CEC function in the same-named menu.
• To automatically switch from the optical or coaxial digital input to one of the other inputs, the source unit must be switched off. For Analog
Line and Bluetooth stopping playback is sufficient.
Sub Out [SUB]
Use the Sub Out function to enable or disable the analog RCA Sub Out connector at the BRA 3 / VRA 3. With enabled output you can control a (wired)
powered subwoofer using a standard RCA cable. To enable resp. disable the output, please do the following:
1
To enter the menu, press the "M" button.
2
Use the "+" or "-" button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
3
Select the menu item Sub Out and confirm with the "OK" button.
4
Press OK and change the setting using the +/- keys. Then press OK, again.