3
77
English
8
If the display shows FAI the allocation has failed and you need to repeat steps 4 to 7. Please try a lower or higher distance between the
speaker and the TV remote control in case the process fails again. Alternatively, try to press the key on the TV remote shorter or longer.
9
To exit the IR Learn menu, press and hold the "M" button for 3 seconds. After one minute without input, the system automatically
returns to the IR menu.
Notes:
• The red “On/Standby” key on the remote control has a dual function. Press it once and the display shows ON which allows the switching
on function to be programmed. If the red “On/Standby” key on the Canton remote control is pressed twice in quick sequence, the display
shows STB and the Standby resp. switching off function can be learned. If your TV remote control has only one key for the “On” and
“Off” functions, both the “On” and “Standby” functions must still be allocated with this command.
• Due to the variety of infrared codes it is not possible to guarantee that every IR remote control signal can be learned by the BRA 3 / VRA 3.
Signals from radio frequency (RF) remote controls cannot be learned, in general!
Direct Input Learn [DIL]
This function allows the user a direct selection of the signal inputs if using a third party remote control.
In addition to the INPUT UP(
) and INPUT DOWN(
) function, you can directly select the signal inputs (e.g. ARC) when using your TV or universal
remote control. That means you can allocate the desired input to a key on your remote control.
1
To enter the menu, press the "M" button.
2
Use the
" "
or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
3
Select the IR Menu [IRM] and press the "OK" button to confirm.
4
Choose the function Direct Input Learn [DIL] and press the "OK" button to confirm.
5
[HD1] flashing on the display and is displayed on the screen for the first HDMI input.
6
You can now assign the HD1 input to a button on your TV remote control.
Note:
If you press this key on the remote control while the speaker is in normal mode, the system switches directly to the HD1 (BDP) input.
7
Press the desired key on the remote control. If the infrared code has been successfully stored by the system, [OK] is shown briefly in the display
resp. "Success" on the screen, followed by the next input.
8
If the code could not be learned, [FAI] appears briefly on the display resp. FAIL appears on the screen to indicate that no code has
been stored. In this case, [HD1] will still be displayed.
9
If you do not press any button on the TV remote control within 15 seconds, the system returns to the IR menu
