Canton DIGITAL MOVIE DM 90, Manual

Page: 61 / 68

61
Deutsch
English
Service Setup Menu
The Service Setup mode of the DM remote control is accessed by
pressing and holding the MENU key, simultaneously pressing the
Power key and releasing them both at the same. The following
functions can be set here: i2C, Start-up Volume, Volume Limiter and
Preset.
i2C
This is used to switch off the internal control of the Canton system
for servicing. After automatic shut-down of the remote control,
reactivation is only possible by disconnecting the sub from the mains
for 10 seconds. For this reason, please ensure that the setting is
always in the „on“ position.
Start-up Volume
This value determines the maximum volume when the DM system is
switched on. If the device is switched off at a lower volume, this
level is maintained.
Volume Limiter
The maximum settable and achievable volume is set here in order to
prevent an unintentionally high level.
Preset
Preset determines the mode in which your DM system is operated.
The display differentiates between function-specific and product-
specific properties.
2.1 (delivery status) or 5.1 mode can appear as functions. The
option exists in 5.1 mode of operating an active or wireless
loudspeaker system via the
„2.1 MODE/5.1 MODE“ pre-amplifier
output. If „ 5.1 Mode DM 2“ is selected, an additional passive center
speaker is required which should be connected at the
„Center“
output. This is not necessary in „ 5.1 Mode DM 1 “, because the
signals are reproduced by the two front speakers.
The product-specific properties relate to the DIGITAL MOVIE system
you have purchased. Select the menu items here that match up
with your system.