Canton DIGITAL MOVIE DM 90, Manual

Page: 42 / 68

42
Connecting the loudspeakers
DM 1/ DM 2
Use the supplied loudspeaker cables to connect the
speakers to the screw terminals „Front Left“ and
„Front Right“ on the back of the subwoofer (strip
approx. 1 cm of the insulation off the cable ends).
Please observe the correct polarity, red for plus (+) and
black for minus (-). Use the markings on the supplied
cable for this purpose. The connection for the center
speaker is only active in
5.1 mode , which can be
switched on via the service setup (see Page 61).
Important: Only connect your active subwoofer to the
mains once all connections to the other audio/video
components have been made. You can then turn the
mains switch to the „ON“ position.
Cut the cable to the required lengths (ideally two cables
of equal length).
Ensure that the stripped cable ends do not have contact
with the back of the housing (risk of short-circuiting!)
Connecting the loudspeakers DM 90
Since the DM 90 is internally wired, connecting the
speakers is not neccessary.