Canon Puncher Unit-BF1, Service Manual

Page: 18 / 48

2
2
2-5
2-5
Controls
Overview
This unit is located in the feed path inside the finisher and sequentially punches holes once
the media stops.
The media loaded from the host machine is fed by the inlet roller and feed roller of the
finisher. When the trailing edge of the media reaches a prescribed location, the media is
stopped for a moment and punched at the trailing edge.
The name and role of motors and sensors used for punching are shown below.
Motor Function Reference
Punch slide motor (M101) Drives the punch slide unit. -
Punch motor (M102) Drives the punch unit. -
Motor Function Reference
Horizontal registration HP
sensor (S101) Detects the punch slide unit home position. -
Punch position sensor (S102) Detects the punch blade position. -
Punch 2-/3-hole sensor
(S103)
Detects the punch hole change. -
Punch HP sensor (S104) Detects the punch blade home position. -
Punch motor clock sensor
(S105) Detects the punch motor clock. -
Inlet sensor (S106) Detects the feeding of media. -
Punch waste full detection
sensor (LED1, PT1(PCB2))
Detects when punch waste is full.
-
Horizontal registration sensor
(LED1 ~ LED5(PCB3)/PT1 ~
PT5(PCB4))
Detects the media far side edge position. -
Punch motor (M102)
Punch slide motor
(M101)
Puncher driver
PCB (PCB1)
Panch waste full detection
PCB (PCB2)
LED PCB (PCB3)
Photosensor PCB (PCB4)
Inlet sensor (S106)
Punch HP sensor (S104)
Punch position sensor (S102)
Punch 2-/3-hole sensor (S103)
Horizontal registration
HP sensor (S101)
Punch motor clock sensor (S105)
F-2-6 F-2-6