4
4
4-16
4-16
Installation Procedure > When installing to the saddle finisher
Installation Procedure > When installing to the saddle finisher
14) Connect a connector of the punch unit.
x1
F-4-39
15) Put the harness of the punch unit in the harness guides, and then attach the re-use band.
Connect two connectors of the punch unit to the two connectors (CN127 and CN128) on the finisher
controller PCB.
x2
F-4-40
16) Connect a connector of the punched waste paper full sensor to the connector
(CN4) on the puncher driver PCB.
x1
F-4-41
17) Using four screws, attach the rear cover of the
saddle finisher removed in step 5).
18) Attach the PCB cover of the saddle finisher
removed in step 4).
19) Using four screws, attach the right inner cover of
the saddle finisher removed in step 2).
20) Attach the supplied punch waste paper box.
F-4-42
Summary of Contents for Puncher Unit-BE1
