3
3
3-7
3-7
Controls > Removing from the saddle finisher
Controls > Removing from the saddle finisher
8) Remove 1 screw and remove the punch unit lock pin.
x1
Note:
• Hold the punch unit at the locations shown below.
• The punch front cover is not attached when
removing the punch unit from the saddle finisher,
but the punch unit holding location is the same.
•
Do not hold the motor gear.
9) Remove the punch unit from the finisher.
Summary of Contents for Puncher Unit-BE1
