Canon Puncher Unit-BE1, Service Manual

Page: 41 / 58

4
4
4-3
4-3
Unpacking and Checking the Contents > Checking the Contents > When installing to the saddle finisher
Unpacking and Checking the Contents > Checking the Contents > When installing to the saddle finisher
Unpacking and Checking the Contents
Checking the Contents
Open the container box and check that none of the included parts is missing.
■
When installing to the finisher
[11]
[3]
[2]
[5]
[4]
[9]
[6]
[12]
[10]
[9]
[8]
[1]
[1] Punch unit ............................................................................1 pc.
[2] Punched waste paper full sensor unit ..................................1 pc.
[3] Punched waste paper box ...................................................1 pc.
[4] Punched waste paper box stopper ......................................1 pc.
[5] Screw (Bind, M3 x 6) ...........................................................1 pc.
[6]*1 Punch unit fixing pin (for finisher) ........................................1 pc.
[7]*2 Punch unit fixing pin (for saddle finisher) .............................1 pc.
[8]*1 Punch latch unit ...................................................................1 pc.
F-4-3
■
When installing to the saddle finisher
[4]
[10]
[10]
[1]
[7]
[2]
[11]
[5]
[3]
[9]*1 Screw (Bind, M4 x 7) ...........................................................3 pcs.
[10]*3 Screw (TP, M3 x 6) ..............................................................3 pcs.
[11] Punch jam label ...................................................................1 pc.
[12]*1 Punch lever caution label .....................................................1 pc.
*1: These are used only when installing this unit to the finisher.
*2: These are used only when installing this unit to the saddle finisher.
*3: Only two screws are used when installing this unit to the finisher, and three screws are used when
installing this unit to the saddle finisher.
F-4-4