1-2
Adjusting the Slit Plate
• Use only the slit plate at the front.
• If you must replace the drum unit, be sure to put the slit plate back to the white marking.
1) Turn off the power switch, and disconnect the power plug from the power outlet.
2) Remove the copyboard glass, and move the No.1 mirror mount to the center, where work is facilitated.
3) Adjust the slit plate at the front by referring to the table below.
If you adjusted the slit
q
by loosening the screw
r
, the change will affect
the area from the center to the rear end.,
Note:
A
A
B
B
1
2
Rear slit plates
(These plates cannot be adjusted.)
1
2
3
4
B
A
If you adjusted the slit
w
by loosening the screw
e
, the change will affect
the image end (up to a point about 30 mm from the rear).
A 3
Leading edge
A 3
{
30 mm (approx.)
Leading edge
Slit adjustment direction
A
B
Image density
Lighter
Darker
