Canon LBP351 Series, Service Manual

Page: 47 / 191

TCP/IP Settings > IPv6 Settings > ON
TCP/IP Settings > IPv4 Settings > Protocol > BOOTP > ON
TCP/IP Settings > IPv4 Settings > Protocol > RARP > ON
When IPSec is set
MEAP-related Information
During execution of an MEAP application which prohibits quick startup
When a login application is switched by SMS
When a job is in progress (including internal jobs in progress such as calibration and cleaning)
When importing setting values using service mode or RUI
When menu setting values are changed by RUI/LUI
Others
When the Main Power Switch is pressed for at least 5 seconds
When an error code or a jam occurs
When a cover is open
When the accumulated time during which the machine is powered ON as well as powered OFFF (with quick startup turned ON)
is 110 hours or more.
When a license has been registered
Energy Saving Function
This machine is equipped with energy saving function.
The following shows energy saving status and condition of transition.
Condition Description Condition of Transition
Panel sleep Panel off Press [Power key].
Engine sleep The panel and engine are turned OFF. When the time to transition to these modes
has elapsed (Default setting: 5 minutes)
* When a USB is connected, the transition
does not occur.
Deep sleep The panel, engine and controller are turned
OFF. (Only Power LED lights up.)
■ Conditions for Not Entering Deep Sleep
Conditions for not entering sleep
When a job is in progress (including internal jobs in progress such as calibration and cleaning)
While a door is open
When an error code or jam occurs
During a firmware update
When the Toner Cartridge is not installed
When information cannot be read from the Toner Cartridge Memory (including a failure of a memory tag and a state in which a memory
tag is not yet connected)
When the life warning of the Toner Cartridge is displayed
2. Technical Explanation (Device)
40