(3/
24
)
LED
(Blinking in
orange)
Error
Error
code
Solution Remarks
Print head not installed,
or not properly installed.
Install the print head properly.
Faulty print head ID.
[1401]
Print head temperature
sensor error.
[1403]
5 times
Faulty EEPROM data of
the print head.
[1405]
Re-set the print head. If the error
is not cleared, the print head may
be defective. Replace the print
head.
[1841
*2
,
1846
*2
,
1851
*1
,
1856
*1
]
Close the inner cover, and press
the Resume/Cancel button.
Inner cover error.
[1850
*1
,
1855
*1
]
Open the inner cover, place the
CD-R tray and press
Resume/Cancel.
6 times
Time-out in CD / DVD
print operation.
[1830
*1
] A prescribed period of time (12
minutes) has elapsed without any
printing since printing was
attempted. Press the
Resume/Cancel button to clear
the error.
Multiple ink tanks of the
same color installed.
[1487] Replace the wrong ink tank(s)
with the correct one(s).
7 times
Ink tank in a wrong
position.
[1680]
Install the ink tank(s) in the correct
position.
8 times
Warning: The ink
absorber becomes
almost full.
[1700/
1701]
Replace the ink absorber, and
reset its counter. [See 2-2.
Adjustment / Settings, (4) Service
mode]
Pressing the Resume/Cancel
button will exit the error, and
enable printing without replacing
the ink absorber. However, when
the ink absorber becomes full, no
further printing can be performed
unless the applicable ink absorber
is replaced.
The error “The ink
absorber becomes
almost full (service
call)” may occur soon.
9 times
The connected digital
camera or digital video
camera does not support
Camera Direct Printing.
[2001] Remove the cable between the
camera and the printer.
