(2/
24
)
1. LIST OF ERROR DISPLAY
1-1. Operator Call Errors (Alarm LED Lit In Orange)
Errors and warnings are displayed by the following ways:
- Operator call errors are indicated by the Alarm LED lit in orange, and messages are displayed
on the printer driver Status Monitor.
- Error codes (the latest 10 error codes at the maximum) are printed in the "operator call/service
call error record" area in EEPROM information print.
Buttons valid when an operator call error occurs:
- Power button:
To turn the printer off and on again.
- Resume/Cancel button: To cancel the job at error occurrence, and to clear the error.
LED
(Blinking in
orange)
Error
Error
code
Solution Remarks
No paper in the rear tray. [1000]
Confirm that the rear tray is
selected as the paper source. Set
the paper in the rear tray, and
press the Resume/Cancel button.
No CD / DVD tray
[1001]
Set the CD / DVD tray, and press
the Resume/Cancel button.
No CD or DVD
[1002]
Set a CD or DVD in the CD / DVD
tray, and inset the CD / DVD tray
in the proper position. Then, press
the Resume/Cancel.
2 times
No paper in the cassette. [1003]
Confirm that the cassette is
selected as the paper source. Set
the paper in the cassette, and
press the Resume/Cancel button.
Paper jam.
[1300]
Paper jam in the rear
guide.
[1303]
Paper jam in the under
guide.
[1304]
Remove the jammed paper, and
press the Resume/Cancel button.
3 times
The front door is closed. [1250]
Open the front door.
The error is detected
at the start of printing
or during printing.
Ink may have run out.
[1600]
Replace the applicable ink tank
and close the cover.
When the error is
cleared by pressing
the Resume/Cancel
button, ink may run out
during printing.
4 times
Ink tank not installed.
[1660]
Install the applicable ink tank(s)
properly, and confirm that the
LED's of all the ink tanks light in
red.
