Canon imageRUNNER ADVANCE 8105, Getting Started

Page: 90 / 256

Protocol Settings
4-4
4
Using a TCP/IP Network
2
In <Use IPv4>, specify the following .
[On] for <Use IPv4>: IPv4 networks can be used.
[Off ] for <Use IPv4>: IPv4 networks cannot be used, regardless of the settings specified for IPv4 on the Settings/Registration screen. The
ARP (Address Resolution Protocol) table is also disabled.
If you set <Use IPv4> to 'Off', you cannot use an SMB/CIFS network.
3
On the TCP/IPv4 Settings screen, press [IP Address Settings]
→
specify the following .
Using a fixed IP address:
[DHCP], [RARP], and [BOOTP]: [Off]
Enter the appropriate values in [IP Address], [Subnet Mask], and [Gateway Address].
It takes about two minutes to check whether the DHCP, RARP, or BOOTP settings can be used. If you do not plan to use one of these
settings, it is recommended that you turn them off.
●
☐