Canon imageRUNNER ADVANCE 8085, Maintenance Manual

Page: 51 / 176

Staple Finisher-F1 PRO/Booklet Finisher-F1 PRO/Puncher Unit-BB1/Booklet Trimmer-D1 (Optional) 1-39
1
Routine Maintenance
Operating the Limited Functions Mode
If a specific message (the service call message) appears on the display, operate the Limited Functions Mode. When the Limited
Functions Mode is set to ‘On’ and make the corresponding function stop its operation, the other functions may be able to perform
normally.
Call your service representative before you operate the module separation switch.
E590
Cause The Puncher Unit-BB1 is out of order.
Remedy You can make copies/prints using functions other than the hole punch function by operating the Limited Functions Mode.
E530, E531, E532, E535, E537, E540, E542, E566, E567, E568, E577, E578, E57a, E57b, E57c, E583, E584
Cause The Finisher is out of order.
Remedy You can only output copies/prints by operating the Limited Functions Mode to restrict all of the functions for the finisher such as
staple and collate.
E503-8004, E5a7, E5af, E5f0, E5f1, E5f2, E5f3, E5f4, E5f6, E5fa, E5fb, E5fc, E5fd, E5fe
Cause The saddle stitcher unit (or the Booklet Trimmer) is out of order.
Remedy You can make copies/prints using functions other than the saddle stitch function by operating the Limited Functions Mode.
E518, E562, E569, E56a, E56b, E56e
Cause The Folding Unit is out of order.
Remedy You can make copies/prints without using the folding mode by operating the Limited Functions Mode.
•
Limited Functions Mode] is displayed only if the finisher is attached.
•
After setting the Limited Functions Mode to ‘On’, the corresponding function will be grayed out on the display, and cannot be used.
•
If E566, E567, or E568 occurs, the function to align sheets that are not aligned is disabled when feeding sheets.
1
Press (Settings/Registration) → [Management Settings] → [Device Management] → [Limited
Functions Mode].
For instructions on setting the Limited Functions Mode from the Service Call Message screen, see “Setting the Limited Functions Mode
from the Service Call Message Screen,” on p. 2-89.