Canon imagerunner advance 4525i, Service Manual

Page: 883 / 1126

SORTER > OPTION
SDL-ALG 1 Set paddle oprtn in sddl unit: Fin-Y1
Detail To set the paddle operation when stacking the paper in the saddle stitcher unit.
Set to 1 when the paddle operation of the last stack paper in the saddle stitcher unit is changed
from one rotation to two rotations.
Use Case When improving the paper alignment of the feed direction at stacking the paper in the saddle
stitcher unit
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Caution When setting to ON, productivity is decreased.
Display/Adj/Set Range 0 to 1
0: OFF, 1: ON
Default Value 0
TRY-STP 1 Stpl stck limit clear: Fin-J1/Y1
Detail To set whether to limit the stack capacity of the stapled copies sheets.
When clearing the limit, the tray height limit is applied instead.
Use Case
When stacking papers beyond the maximum number of stapled copies sheets
Adj/Set/Operate Method
Enter the setting value, and then press OK key.
Caution
When the stacking limit is cleared, stacking capacity increases, but stacking performance
decreases.
Display/Adj/Set Range
Fin-J1: 0 to 1
Fin-Y1: 0 to 3
0: Normal specification
1: Clear the limit of stack capacity of the stapled copies, and apply the tray height limit
2,3: Not used
Default Value 0
TRY-LMT 1 Set stack limit of stack tray: Fin-Y1
Detail To set whether to limit the stack capacity of the stack tray.
Set to 1 when the stack capacity of the stack tray for the small size paper is changed from about
3,000 sheets to about 1,000 sheets.
Use Case When the stacking performance decreases by the curled paper during stacking a large amount of
the small size paper
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Display/Adj/Set Range 0 to 1
0: OFF, 1: ON
Default Value 0
FR-ST-SW 1 Stp-free Stp Set in No Stp Ctrdg: Fin-J1
Detail When the staple cartridge is absent, staple-free stapling is not actually performed in the default
setting while a job with staple-free stapling has executed since the finisher behaves in non-sort
mode. Set to "1" to enable the staple-free stapling without staple cartridge.
Use Case
When utilize the staple-free stapling without staple cartridge
Adj/Set/Operate Method
Enter the setting value, and then press OK key.
Caution
If a staple cartridge should be left in the finisher with the setting turns to "1" and the cartridge sits
unstable, error; 1C32 or E532 may come out when staple-free stapling is performed.
Display/Adj/Set Range
0 to 1
0: OFF, 1: ON
Default Value
0
8. Service Mode
870