Canon IMAGERUNNER 7095 PRINTER, Service Manual

Page: 102 / 615

Chapter 4
4-7
XX= "01" to "FF"
T-4-2
XX YY
XX
CHK
-
TYP
E
Partition Description
Occurrence at
time of start-up
Occurrence
during normal
execution
03 05
00,0
1,02,
04
11,2
1
13,2
5
10,12,
14,22,
23,24
Action Action
01
1
FSTDEV compressed image data (e.g., Box)
*1 *5
*9 *10 *11 *12
02 IMG_MNG file management table, profile
03 FSTCDEV job archiving (changing)
04
2
APL_GEN general-purpose data
05 TMP_GEN general-purpose data (temporary file)
06 TMP_FAX not used
07 TMP_PSS for PDL spool (temporary file)
08 3 PDLDEV PDL-related file
09 4 BOOTDEV
firmware (system, MEAP, key, certificate, PDF
dictionary, RUI, content, voice dictionary)
*3 *8
10 5
APL_MEA
P
MEAP application
*1 *5
11 6
APL_SEN
D
address book, filter
*2 *6
12 7 APL_KEEP for non-initialization data storage *3 *8
13 8 APL_LOG system log *1 *5
FF 0
not
specified
check for and recovery of HDD full-fault
sectors
*4 *7
YY Description Action
*1
03
The ongoing write
operation is interrupted
(at start-up).
- Set the partition number in question for CHK-TYPE, and execute HD-
CLEAR; then, turn off and then back on the power.
- Enter CHK-TYPE in question (for the partition), and execute HD-CLEAR;
then, turn off and then back on the power.
*2
- Ask the user to download the address book data using a remote UI.
- Set the partition number in question for CHK-TYPE, and execute HD-
CLEAR; then, turn off and then back on the power.
- Start download mode, and perform full formatting using the SST and
reinstall the system software; then turn off and then back on the power.
*3
The recovery operation for the boot partition is not possible without the use
of the SST in save mode.
- Set CHK-TYPE=0, and execute HD-CHECK; then, turn off and then back
on the power.
- Start download mode, and perform full formatting using the SST and
reinstall the system software; then, turn off and then back on the power.
*4
- Set CHK-TYPE=0, and execute HD-CHECK; then, turn off and then back
on the power.
- Set CHK-TYPE=1, 2, 3, 5, and execute HD-CLEAR; then, turn off and
then back on the power.