Canon IMAGERUNNER 7095 PRINTER, Service Manual

Page: 87 / 615

Chapter 2
2-40
12) Plug the cable [2] into the speaker unit [1].
F-2-155
13) Run the cable [1] through the cord guide [2]
and mount the cord guide cover [3].
Be sure that there is no slack of the cable.
F-2-156
14) Route the cable [1] under the cable [2] and
through the 4 cord guides [3]; then,
fix it in place using the 2 clamps [4].
Attach the cord guide cover [5] (4 locations).
Be sure that there is no slack of the cable.
F-2-157
15) Mount the ferrite core [1] on the cable.
The length [2] should be less than 50mm.
F-2-158
16) Plug the cable [1] into the terminal [2] of
voice board.
F-2-159
17) Plug the power cable of host machine into a
wall outlet
18) Turn on the main power switch.
19) Check if the voice board is recognized.
Enter service mode (" "->"2"& "8"at the
same time ->" ")
COPIER > DISPLAY > ACC-STS > PCI1
If 'voice board' is indicated for PCI1, the board
is correctly recognized by the machine.
3. Making Settings After Installation
To make use of the Voice Guidance Kit-A2 after
turning on the host machine, you need to make
the following settings in Additional Function:
1) Additional Function > System Setting >
Voice Guide Manegement Setting > Use Voice
Guide.
2) Select [ON].
3) Press [OK].
default : OFF
4. Checking the Operation
- To Enable
1) Hold down the Reset key 3 sec or more.
2) See that the copy count on the screen is
enclosed in red, indicating 'Voice Guidance' is
ready for use.
- To Disable
1) Hold down the Reset key for 3 sec or more.
[1]
[2]
[3]
[2] [1]
[1] [2] [5] [3]
[4] [3] [5] [5]
[1]
[2]
[2]
[1]