Canon imageRUNNER 2270, Service Manual

Page: 546 / 994

Chapter 13
13-15
4) Execute the following service mode
items:
- COPIER > FUNCTION > DPC > D-
GAMMA
13.5.3
After
Replacing the
Main Controller
PCB
0007-5188
If you are replacing the main controller
PCB, be sure to transfer the following
components from the old to new PCB:
[1] boot ROM
[2] HDD
[3] image memory (SDRAM)
[4] counter memory PCB
F-13-23
If the user uses NetSpot Accountant
(NSA) in Combination with a Card
Reader
The SDRAM of the main controller retains
card ID used by NSA. If you have replaced
the main controller, you will have to
download the card data from NSA once
again to permit NSA to perform statistical
operations.
If you have formatted the HDD and
downloaded the system software, you will
have to go through a specific set of steps:
1) Format the HDD.
2) Download the system software.
3) Make the following selections:
COPIER>FUNCTION>INSTALL>CAR
D.
4) Enter a card No.
Enter the first of the numbers that will be
used for group control, and press the OK
key (e.g., if you are planning to use cards
from No. 1 thorough No. 100, enter '1').
5) turn off and then on the main power.
6) Check the count control mechanism in
user mode.
system control setup>group ID
control>count control
check to see as many as 'ID00000001
through ID00001000' have been prepared.
7) Set the IP address in user mode.
system control setup>network
setup>TCP/IP setup>IP address
Set 'IP address', 'gateway address', and 'sub
net mask'.
8) Enter a number of your choice in user
mode.
system administrator info setup>system
control group ID>system control ID No.