Canon imageCLASS LBP325dn, Service Manual

Page: 208 / 252

E015-0003-- Cassette 3 (Option Cassette 2) lift-up error
Detection Description Cassette 3 (Option Cassette 2) Lifter Motor error
Remedy
1. Check the Cassette 3 Lifter Motor (dropout, gear tooth jump, etc.).
2. Check the connector between the Cassette 3 Lifter Motor and the Cassette 3 Driver PCB.
3. Replace the Drive Unit (the Cassette 3 Lifter Motor included)
4. Replace the Cassette 3 Driver PCB.
E015-0004-- Cassette 4 (Option Cassette 3) lift-up error
Detection Description Cassette 4 (Option Cassette 3) Lifter Motor error
Remedy 1. Check the Cassette 4 Lifter Motor (dropout, gear tooth jump, etc.).
2. Check the connector between the Cassette 4 Lifter Motor and the Cassette 4 Driver PCB.
3. Replace the Drive Unit (the Cassette 4 Lifter Motor included)
4. Replace the Cassette 4 Driver PCB.
E066-0000-- Environment Sensor error
Detection Description Failure of the Environment Sensor was detected.
Remedy 1. Replace the High Voltage Power Supply PCB (the Environment Sensor included)
2. Replace the DC Controller PCB.
E06F-0068-- EEPROM access error
Detection Description Failure of the EEPROM was detected.
Remedy 1. Turn OFF and then ON the power.
2. Replace the Main Controller PCB.
E100-0000-- Laser Scanner error
Detection Description Failure of the Laser Assembly in the Laser Scanner Unit
Remedy 1. Check the connector of the Laser Scanner Unit.
2. Replace the Laser Scanner Unit.
3. Replace the DC Controller PCB.
E110-0000-- Scanner Motor error
Detection Description Error in the initial operation of the Scanner Motor
Remedy 1. Check the connector of the Laser Scanner Unit.
2. Replace the Laser Scanner Unit.
3. Replace the DC Controller PCB.
E110-0001-- Scanner Motor error
Detection Description Error in rotation of the Scanner Motor
Remedy 1. Check the connector between the Laser Scanner Unit and the DC Controller PCB.
2. Replace the Laser Scanner Unit.
3. Replace the DC Controller PCB.
E196-0000-- Firmware error (The host machine or the option cassette)
Detection Description Engine firmware error
Remedy
1. Turn OFF and then ON the power.
2. Update firmware.
3. Replace the DC Controller PCB
E196-0002-- DC Controller internal error
Detection Description The memory area in the DC Controller cannot be accessed.
Remedy 1. Turn OFF and then ON the power.
2. Update firmware.
3. Replace the DC Controller PCB
E245-1011-- Host machine FRAM write error
Detection Description Host machine FRAM write error was detected.
Remedy Replace the Main Controller PCB.
8. Error/Jam/Alarm
198