Canon image RUNNER 3245, Getting Started Manual, Page: 64 / 180

Protocol Settings 5-4
5
Using a TCP/IP Network
2
In <Use IPv4>, specify the following.
[On] for <Use IPv4>: IPv4 networks can be used.
[Off ] for <Use IPv4>: IPv4 networks cannot be used, regardless of the settings specified for IPv4 on the
Additional Functions screen. The ARP (Address Resolution Protocol) table is also disabled.
If you set <Use IPv4> to 'Off', you cannot use a NetBIOS network.
3
On the TCP/IPv4 Settings screen, press [ IP Address Settings]
→
specify the
following.
Using a fixed IP address:
[ DH CP], [ RA RP], and [ BOO TP]: [Off ]
Enter the appropriate values in [IP Address], [ Subnet Mask], and [ Gateway Address].
It takes about two minutes to check whether the DHCP, BOOTP, or RARP settings can be used. If you do not
plan to use one of these settings, it is recommended that you turn them off.
Obtaining automatically an IP address:
[DHCP], [RARP], or [BOOTP]: [On]
If this information cannot be obtained via DHCP, RARP, or BOOTP after you restart the machine, enter
the IP address, subnet mask, and gateway address to use the settings entered in this step.
●
☐
●
☐