Canon ColorWave 3800, Operation Manual

Page: 138 / 358

Configure the roll-to-roll mode in WebTools Express
Introduction
When you want to use the take-up unit, your printer has to be in the roll-to-roll mode. When you
enable the roll-to-roll mode, the printer will not cut between pages. You can also configure the
roll-to-roll mode on the user panel.
NOTE
• When the roll-to-roll mode is enabled, each print job is delivered to the [Back output]; even
when you set the [Top delivery tray] as output location for your prints.
• To calibrate the printer the roll-to-roll mode must be disabled.
• When the printer is in roll-to-roll mode, you have to cut the media before you can replace a
toner cartridge.
Procedure
1.
Open the [Preferences] - [System defaults] tab.
2.
Click on [Edit] in the [Job management] section, or click on the [Roll-to-roll mode] setting.
3.
Select [Enabled] or [Disabled].
4.
Click [Ok] to confirm, or [Cancel] to reject your entries.
Configure the roll-to-roll mode in WebTools Express
138 Chapter 3 - Define your workflow with WebTools Express