Canon Color Universal Send Kit-Q1, Service Manual

Page: 75 / 96

Chapter 4
4-13
Local area connection confirmation from a Windows Vista PC
From START, go to Control Panel, then Network and Common Centre > Network Connections and Management > Local Area Connections > Properties.
Open the Properties for Internet Protocol Version 6 (TCP/ IP). Select 'Obtain IPv6 Address Automatically' then press OK.
From START, go to All Programmes > Accessories > Command Prompt.
Enter the following command and the IPv6 link local command displayed on the unit touch panel, then press Enter.
At this time, if Ping does not work with only the link local address, enter the Scope ID.
< IPv6address > % <Scope ID >
E.g. fe80::200:85ff:fead:bac2%4
If the unit responds, a connection has been made.
F-4-30
IPv6 connection confirmation from the iR main unit touch panel
Carry out the following procedures in order to check the IP address of a Windows Vista PC.
From START, go to All Programmes > Accessories > Command Prompt.
Enter the following command,
netsh interface ipv6 show address
The display illustrated below will appear.
This is a local network environment with no DHCPv6 server.
F-4-31
In the case of the above example,
note down 'fe80::206:5bff:febd:3ad9' , then, from the main unit touch panel,
Additional Functions > System Settings > Network Settings > TCP/IP Settings > IPv6 Settings > PING Command
Against IPv6 address, enter the IPv6 address of the Windows Vista PC written down earlier, and press Start.
If 'Response from the host' is displayed, a connection has been made.