Canon Color Bubble Jet BJC-8200, Service Manual

Page: 30 / 105

2.4 Grease Application
Apply greases at the points shown below.
Apply a thin film of grease using the flat brush. For the grease (EU-1) for the grease
pad, do not use a brush but apply directly. For printer disassembly and reassembly
procedures, refer to the parts catalog.
When applying greases, be careful to not get any on the wiper, cap, or
encoder film. If grease is applied to them, wipe them clean immediately.
Part 2: MAINTENANCE BJC-8200
2-8
Figure 2-8 Grease Points
Cam Sliding Surface
Approx. 24 mg (Molykote PG-641 )
Cam Sliding Surface
Approx. 24 mg
(Molykote PG-641 )
Grease Pad
Approx. 35 mg (EU-1)
Eject Roller Gear Teeth (apply to all teeth evenly)
Approx. 60 mg (Molykote PG-641 )
LF Gear Teeth (apply to all teeth evenly)
Approx. 72 mg (Molykote PG-641 )
Feed Roller Sliding Surface
Approx. 24 mg (Molykote PG-641)
Feed Roller Sliding Surface
Approx. 12 mg (Molykote PG-641)
Paper Thickness Lever
Approx. 12 mg
(Molykote PG-641)
Guide Frame Underside (apply
a thin coat of grease over the entire surface)
Approx. 48 mg (Molykote PG-641)
Guide Shaft Sliding Surface
(apply the proper amount of grease so as not to drip)
Approx. 90 mg (EU-1)
Feed Roller Gear Teeth
(apply to all teeth evenly)
Approx. 96 mg (Molykote PG-641)
CAUTION