26
137384
English
Scalpel - Owner’s Manual Supplement
1. Down Tube
2. Cover
3. Tool Carrier
4. Multi-Tool (Fabric)
5. Dyna Plug Tire Repair Tool
6. CO2
7. Retaining Screws
8. CO2 Strap
a. Tool Tray
b. Tray Lip
c. Tire Tool Clip
d. Strap Tensioning
e. Tray Latch
f. Cable guide
Identification
Down Tube - Cover/Tool Carrier
The downtube of the Scalpel supports the use of a tool carrier (3) developed specifically for the frame.
The tool carrier is an optional item. A water bottle cage can be mounted above the carrier. The tool
carrier contains a specific multi-tool (4), a tire repair plug tool (5), and a mounting for a C02 tire inflation
device (6). The carrier position on the down tube can be adjusted. Notice the ovalized mounting holes.
See
Replacement Parts
for ordering information.
A blank cover (2) is in place when the optional tool carrier is not present. Do not ride the bike without
either the cover or the tool carrier securely attached to the downtube.
Both the cover and tool carrier also function to secure internally routed cables. A small cable guide is
attached to the underside of both. Setup for this guide is explained in the Cable Routing section of this
manual.
To install the multi-tool:
1. Slide out the tool tray (a) until it stops.
2. Insert the multi-tool (4) onto the tray behind the tray lip (b).
3. Slide the tray and tool back into the tool body until the latch (e) (located on the underside of the
sliding tray), clicks or latches into the tool body. You can feel the click when latched.
Confirm that the tray is latched by lightly pulling the tray. the tray, when latches should not slide
out easily.
NOTICE
Make sure the tool tray is always latched. If the tray is not latched correctly, the tool will not be
captured securely and may be lost during a ride.
e
f
a